![]() ![]() On the below diagram it is however Reset and Kill. The two buttons are labeled on the board as RST and Play. Are these seperate lines, or can I use either of these? This allowed me to use the original mounting holes by drilling and tapping into the edge of the Plexiglass. ![]() What is the max power that can run through these pins (VM and air assist)?ĭC V-in is stenciled as max 36V, however the DC in jack is labeled as max 24v. Here is a side picture of how I mounted the Cohesion3D board to a 1/4 piece of plexiglass. This is no problem, but then it requires an extra SSR inbetween. We have an electronic valve that opens with 24v, but I cannot find if the VM+ / - is a continues powersource, or switched on/off with laser power just like the 5V air assist. What I am looking for is more detailed information on wiring, amps and pinout for several scenarios:Ĭompressed air is run throughout the building. When I received the board I noticed there it not an awefull lot of detailed technical information on the board nor attached / found online. ![]() While we are engineering the full machine, I already bought the Cohesion3D board to start prototyping and configuring. Cohesion3D Laserboardįirmware: Whatever it came with. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |