![]() ![]() To charge Cop Carr using a wall outlet, start by assembling the table stand following instructions on the top of page 5.Ģ. When charging is complete, the indicator light will turn OFFġ. ПРИМІТКИ: if Cop Cam^ is charging in your computer/laptop, it will ONLY charge NOT recordģ. While the camera is charging in your computer/laptop, the indicator light will be alternately flashing red and green. ПРИМІТКИ: USB port may be located either on the left or right side of your computer/laptopĢ. To charge Cop Cam using your computer/laptop, plug the Micro-USE connector end of the supplied USB cable into the charging port of the camera (figure B) Once the Micro-USE cable is plugged into the Cop Cam-, plug the other end of the cable into the USE port of your computer / laptop (figure C) ПРИМІТКИ: When the indicator light starts to flash red every 1 second, the battery has 1D16 charge remaining until plugged into a power source.ġ. When the indicator light begins to flash red every 1 second, the battery is low. To check the battery, turn Cop Cam- ON by pressing and holding the POWER/RECORD button for 4 seconds (Figure A), Indicator light is solid red when fully charged.Do not expose to temperatures below 32’F or above 104F.Do not place outdoors unless protected.Cop Cam- is not waterproof, do not expose to wet or damp Середовища.Clean the camera lens only with a soft cloth_.Keep away from strong magnets and high voltage.To protext the Cop Cam and recordings from damage: ![]() Будь ласка, повторноview the state and local laws of your jurisdiction regarding using video recording devices.IMPORTANT SAFETY INSTRUCTIONS, READ AND FOLLOW ALL WARNINGS AND INSTRUCTIONS BEFORE USING THIS PRODUCT. LED light will alternately flash red and green. КРОК 4: To charge Cop Cam”‘, plug into computer/laptop. (Figure C) Use included USB cable to connect Cop Cam”‘ to your Computer/Laptop. КРОК 3: To retrieve footage, remove memory card by pressing inward to release, then pull out of slot. To take a photo quickly press the POWER/RECORD button once. КРОК 2: To switch to photo mode press and hold the POWER/ RECORD button for 2 seconds. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |